Customer Service Blogger — Customer Service Blogger

▶If the speaker is no sound after installed the new radio, there are two possible reasons: 1)If the left or right speaker is not working, it is very likely that the speaker wire is not making good contact.You first check whether the pins of the speaker on the power adapter are in good contact. The power plug may loosen or deform the speaker pins during wiring, causing poor contact. As shown in the right figure, please check whether it is loose. After connecting the power cord, if the speaker pin is loose, you can plug it in directly to make...

Attention: After installing the camera, please test it by closing the trunk to avoid the camera not working due to the reverse lights not functioning. If you still encounter installation issues, please refer to the instructions and contact our customer service. 99% of the problems can be resolved. [YX2216 connect guide]:https://www.youtube.com/watch?v=H0u9xO1cTL0 ................................................................................................................................ If your car has a original  factory back camera , please check the picture below and judge whether your camera is RGB or not  .As our experience , if your original  radio is RNS510/315/RCD510,the factory back camera is RGB .     ---If you still want to keep...

[Guide video] https://www.youtube.com/watch?v=Wu_RwyyR1k4&list=PLVzEQJIHPR7s6HLdUh8JCgFqxhVMWTUqK Due to the variety of vehicle models and designs of the CAN bus, please refer to the table below to properly connect the Anti-leakage Plug, decoder box, and decoder power plug in order to ensure proper communication on the CAN bus   1.After connecting the wires, please do not rush to reinstall. First, start the vehicle, set the CANBUS decoder box to the correct vehicle model, and then perform the test. The CANBUS decoder box can be set as follows:   2.If the functions are normal, the power on/off is normal, and twisting the car headlight switch can...

Installation Guide for Original MIB Interface Camera If your car is equipped with a Volkswagen original MIB camera with the blue interface, simply plug the blue connector directly into the corresponding position of the quadlock adapter. This is a detailed diagram of the power connector. It includes various scenarios, and you can refer to the parts you need.     If your car is equipped with a Volkswagen original MIB camera, your original rear camera should could work with our RCD360pro2 version .  If your original MIB camera could not work , please send us pictures to show us the power plug of your camera,...

Attention: After installing the camera, please test it by closing the trunk to avoid the camera not working due to the reverse lights not functioning. If you still encounter installation issues, please refer to the instructions and contact our customer service. 99% of the problems can be resolved.   If your car is not built-in camera, we recommend purchasing our company's camera to ensure normal use of the product. [camera6] https://www.scumaxcon.com/products/av-input-rcd330-ruckfahrkamera-einparkhilfe-lizenzinhaber-autokamera-schwarz?_pos=1&_sid=960cb383a&_ss=r If you choose our  Standard Universal Camera , Open the hood and close the trunk before installation!! Test the camera first, and wire it when the image appears normally. Here is...